​

Waterjet systems and the 5 benefits that it is able to offer

 

There are many benefits that you can get from a water jet cutting equipment and it is important that you know all about it before you start using one or even if you are already in the verge of using the waterjet technology. In order for you to make a good decision regarding the waterjet technology for your business, it would be wise to read this article so that you can learn more about the benefits that it is able to provide.

 

To begin with, there are two kinds of waterjet cutting methods that you should know of which is the abrasive and pure waterjet cutting. When you are going to cut soft materials such as paper or foam, it would be best to use the pure waterjet cutting method where only water stream is used for cutting. So that the abrasive waterjet cutting method will work, a granular abrasive needs to be added in the water stream. When you need to cut ceramics, metal, or any hard materials, the method that you should use is the abrasive waterjet cutting because the granular abrasive will add power to the cutting stream. Check out omax accessories here. 

 

Here are some of the benefits that you need to know about the waterjet technology that can widen your understanding about it:

 

1. There is no limitation when it comes to the materials

There are a lot of materials that you can cut with the use of the water jet cutting systems such as plastics, composites, rubber, ceramics, rock or stone, and metals. The waterjet cutting systems will be able to perform better if a granular abrasive is being added since it will be able to cut materials up to a 200mm thickness.

 

 

2. HAZ or the heat affected zone is among some of the things that you don't have to worry about

One of the major advantages of the waterjet systems is the fact that it is composed of a cold cutting method so there is no need for you to be apprehensive about the heat affected zone or the HAZ. Clean cuts are being given off by cold cutting as well as the increase in the safety of the operator by making sure all risks of burns are eliminated. 

 

3. Materials are not being distorted

There is no need for you to worry that the material will be deformed especially if it is a hard one such as metal, because the cold cutting method makes sure that any heat exposure will be taken care of. You can be sure that you will be able to get a smooth finish as well as a burr-free cut.

 

4. You don't have to do any additional finishing process

The products will be provided with the highest cutting quality with accurate results that is why you do not need to worry about any finishing process that you might need to apply.

 

5. Hazardous waste is no longer present

There is apparently a growing importance of a friendly environmental process in the industry these days.

 

Find out more about water jet cutters at https://www.youtube.com/watch?v=n3gMUKNfoas.